Audio Unit Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
When working on electronic components, make sure the work area is clean and dust free.
Make sure your hands are clean and free of oils and grease.
If you are replacing the audio unit, write down the audio presets (if possible), and enter them into the new audio unit.
With XM: If you are replacing the audio unit, register the new XM I.D. number by calling 800-852-9696. The XM I.D can be found on a label attached to the audio unit.

3. Audio Unit Assembly - Remove
1.
Remove the bolts (A).

2.
Disconnect the connector (B) from the center display unit.
3.
Remove the harness clip (C).
4.
Pull out the audio unit assembly (A) slightly.
NOTE: Do not grab the top edge of the center display unit (B) when removing the audio unit.
5.
Disconnect the connectors form the audio unit, and remove it.

5. Audio Unit Bracket - Remove
1.
Disconnect the connector (A).
2.
Remove the brackets (B).

6. Audio Cover - Remove

7. All Removed Parts - Install
1.
Install the audio unit in the reverse order of removal.
NOTE:
Make sure all the connectors are secure.
After Installation, do the System Links in the System Diagnostic Mode to confirm that there are no problems in the system.