Intake Manifold Removal and Installation
1. Intake Manifold - Exploded View

Exploded View



NOTE: Refer to the Exploded View if needed during this procedure.

2. Insulator - Remove


NOTE:
Do not disconnect the water bypass hoses.
Do not bend the water bypass hoses excessively.

6. External Item - Remove
1.
Disconnect and remove the following intake manifold external items:
Harness clamp (A)
Bracket (B)
PCV hose (C)
EVAP canister purge valve hose (D)
Turbocharger bypass control valve solenoid hose (E)
Brake booster vacuum hose (F)
Hose clamp (G)

7. Intake Manifold - Remove

8. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE:
Tighten the bolts/nuts in three steps; tighten the bolts/nuts until the bolts/nuts sit on the intake manifold, tighten the bolts/nuts until the gasket is compressed, tighten the bolts/nuts to specified torque.
After installation, check that all tubes, hoses, and connectors are installed correctly.