Body Control Module Removal and Installation

NOTE:
Without keyless access system: If the body control module is replaced, do the immobilizer system registration. If the original body control module is installed, confirm that all systems work properly.
With keyless access system: If the body control module is replaced, do the keyless access system registration. If the original body control module is installed, confirm that all systems work properly.
The body control module has a component of the immobilizer system. The body control module must be registered when the body control module is replaced, or the vehicle will not start.

1. Body Control Module - Remove
1.
Disconnect the connectors (A).
2.
Remove the body control module (B).

2. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

3. Immobilizer System - Register (Without Keyless Access System)

NOTE: If the body control module is replaced, go to step 1. If the original body control module is installed, go to step 6.
2.
Turn the vehicle to the ON mode.
3.
Select IMMOBI from the SYSTEM SELECTION MENU, then select IMMOBILIZER SETUP.
4.
Select the REPLACE MPCS/MICU/IMOES/VSA MODULATOR, then select the suitable menu from the HDS indications.
5.
After registration, confirm that the vehicle will start.
6.
Confirm that all systems work properly.

4. Keyless Access System - Register (With Keyless Access System)