Fuel Fill Door Lock Actuator Removal, Installation, and Test
1. Left Rear Inner Fender - Remove


2. Trunk Rear Side Trim Panel (Left Side) - Remove


3. Fuel Fill Door Lock Actuator - Remove

2-door

4-door
1.
Remove the clip(s) (A).




2-door

4-door
2.
Remove the grommet (A).
3.
Disconnect the connector (B).
4.
While pressing the tabs (C), remove the fuel fill door lock actuator (D).
5.
Remove the fuel fill door release lock (E).

4. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. Fuel Fill Door Lock Actuator - Test
1.
Check the fuel fill door lock actuator (A) operation by connecting power and ground according to the table.
NOTE: To prevent damage to the actuator, apply battery voltage only momentarily.
2.
If the actuator does not operate as specified, replace the fuel fill door lock actuator.