Wiper Arm/Nozzle Adjustment
Except Japan Production

1. Wiper Arm/Nozzle - Adjustment
Adjust the washer nozzles by gently gripping, and then moving, the outside of each nozzle (A).
Do not insert tools into the nozzle hole (B), as it may cause the washer fluid to spray incorrectly.


Wiper Arms Auto-Stop Position
1.
Turn the vehicle to the ON mode, then turn the wiper switch ON, and then back OFF.
2.
When the wiper arms stop at the auto-stop position, make sure that they are at the correct position.
a: Position at about 54.8 mm (2.157 in) from the end of the windshield to the end cap of the wiper blade (C).
b: Position at about 51.6 mm (2.031 in) from the cowl cover (D) to the end cap of the wiper blade.


Washer Nozzle Position
3.
When you turn on the washer, make sure 50 % or more of the washer fluid lands within the spray area. If the spray area is not within the standard positions, adjust the nozzle(s).
d: Position at about 251 mm (9.88 in) from the windshield center line (E).
e: Position at about 159 mm (6.26 in) from the end of black ceramic gradation area (F) at the lower windshield.
f: 2.6 degrees angle to the vertical line (G).

Japan Production

1. Wiper Arm/Nozzle - Adjustment
Adjust the washer nozzles by gently gripping, and then moving, the outside of each nozzle (A).
Do not insert tools into the nozzle hole (B), as it may cause the washer fluid to spray incorrectly.


Wiper Arms Auto-Stop Position
1.
Turn the vehicle to the ON mode, then turn the wiper switch ON, and then back OFF.
2.
When the wiper arms stop at the auto-stop position, make sure that they are at the correct position.
a: Position at about 40.3 mm (1.587 in) from the end of the windshield to the wiper blade (C).
b: Position at about 38.5 mm (1.516 in) from the cowl cover (D) to the end cap of the wiper blade.


Washer Nozzle Position
3.
When you turn on the washer, make sure 50 % or more of the washer fluid lands within the spray area. If the spray area is not within the standard positions, adjust the nozzle(s).
d: Position at about 250.3 mm (9.854 in) from the windshield center line (E).
e: Position at about 142.6 mm (5.614 in) from the end of black ceramic gradation area (F) at the lower windshield.