Rear Brake Caliper Removal and Installation
3. Parking Brake - Release


4. Connector (Electric Parking Brake Actuator) - Disconnect
NOTE: If the connector lock tab is difficult to release, push in on the connector body before pushing on the release lock.


6. Brake Caliper Body - Remove (If necessary)
1.
Remove the housing clip (A).
2.
Remove the caps (A).
3.
Remove the pin bolts (B).
4.
Remove the caliper body (C).


7. Brake Caliper - Remove
NOTE: Use new brake caliper mounting bolts during installation.


9. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

11. Brake Caliper After Install - Check
1.
Turn the vehicle to the ON mode.
2.
Apply and release the parking brake 2 times, then make sure that the brake system indicator (red) goes OFF.
NOTE: If the brake system indicator (red) does not go OFF, check for a poor connection at the electric parking brake actuator connector.
3.
Turn the vehicle to the OFF (LOCK) mode.